
The ONEWAY Screw Chuck was designed in
response to a requirement for making small parts.
It is especially well suited for projects such as drawer knobs and other items where holding possibilities are limited.
Its patented design allows the use of any length of slotted, Phillips, or square head
(Robertson) screw from #8 to #10.
The hex bit seats firmly into the screw head. A set screw then pushes the hex bit
forward and locks the wood screw from the rear against the brass head in the front.
Small parts can be drilled and held with the same screw size that will be used for
installing the piece when it is finished.
An aluminum 3" faceplate (inset above) is provided with the #2 MT Screw
Chuck. This allows you to turn slightly larger pieces with increase safety and
peace of mind.
Weight
Approximate Weight of Package: ½ lb
|